I 3D printed a small bracket and left it in the alcohol over the weekend, when I took it out it was all distorted:
- Good print in the alcohol 10 mins vs bad print left in a weekend.
Lez
Print distorted by the alcohol.
-
Lez0
- Reactions:
- Posts: 401
- Joined: October 8th, 2017, 10:21 am
- Location: Spain
- 3D Printer(s): JGAurora A5S, Anycubic Photon, Saturn 2
Print distorted by the alcohol.
I sometimes leave my prints in the alcohol for a while before I clean them with a brush and take them out to be cured, usually only a few hours, or at most a day.
I 3D printed a small bracket and left it in the alcohol over the weekend, when I took it out it was all distorted: I never expected it to distort this much. The parts are just over an inch square.
Lez
I 3D printed a small bracket and left it in the alcohol over the weekend, when I took it out it was all distorted: I never expected it to distort this much. The parts are just over an inch square.
Lez
-
LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Print distorted by the alcohol.
Your print got drunk =)