Polyalchemy Elixire Gold Rush

Discussion of brand name filaments (ColorFabb Brand, NinjaFlex, Taulman, etc.)
Post Reply
B_HepSpringer
Reactions:
Posts: 5
Joined: August 6th, 2017, 7:09 am
3D Printer(s): Ultimaker 2 - BCN Sigma

Polyalchemy Elixire Gold Rush

Post by B_HepSpringer » August 11th, 2018, 3:17 pm

Been trying to print with this stuff but having loads of problems tried different settings in S3D but still rubbish
temp 215
layer ht .20
speed 1450 mm/min
its when the layers change you can see very clearly the change over even in vase mode where the layer changes to the next will post a pic tomorrow but at moment its heading for the Bin..


or I forgot im using the matchless nozzles from 3dSolex

I turned the extrusion multiplier down to 88 from 1.0 which helped a bit, but its still terrible.....

User avatar
LePaul
Reactions:
Posts: 3108
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Re: Polyalchemy Elixire Gold Rush

Post by LePaul » August 11th, 2018, 5:01 pm

I've printed with it extensively and did a video on it a while back


Post Reply

Return to “Special brand filaments”

Who is online

Users browsing this forum: No registered users and 0 guests