S3D Startup Script

Discussion about Simplify 3D software
Post Reply
B_HepSpringer
Reactions:
Posts: 6
Joined: August 6th, 2017, 7:09 am
3D Printer(s): Ultimaker 2 - BCN Sigma

S3D Startup Script

Post by B_HepSpringer » November 2nd, 2018, 3:40 pm

Hello hears hoping someone can help me?? I'm trying to get a new start up script to work but when I produce the code S3D is installing the 7 lines below.. I would like to stop this,, the G and M codes are in my script along with the heat setting,, but these are extra, if I ignored and run the code it would heat up cool down and re heat again,, which I want to avoid,,, any ideas how to stop this code>>>
G90
M82
M106 S0
M140 S60
M190 S60
M104 S205 T0
M109 S205 T0

Post Reply

Return to “Simplify 3D”