Decided to help protect my home with some radial lead thermal fuses, this will allow for a max temperature for the the hot-bed.
The TCO (Thermal Cut−Off) responds to temperature by cutting of the power the the effective circuit.
Looking at this Thermal Fuse 133 °C 15 A 250 V, I have never raised the bed temperature over 100C.
Want to attach 4 in series to the underside of the bed, this circuit could act a emergency cut off switch.
The Thermal Fuse has a normally closed state when operating under normal conditions, when the bed gets too hot they pop like a fuse.
This could act as a switch in the firmware to turn system power off, or it could route the AC power to the system power supply.
This type of TCO has been protecting you houses for years in your coffee pots, crock pots, most of your small kitchen appliances.
Looking for a simple way to utilize this in 3D Printers.
Any suggestions...
Bed Thermal Fuse
Electronics talk! Arduino UNO, Raspberry Pi and more
- Roberts_Clif
- Reactions:
- Posts: 1386
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Jump to
- Announcements
- ↳ News and Announcements
- ↳ Feedback, suggestions and more
- 3D Printers
- ↳ General / RepRap Printers
- ↳ HICTOP RepRap Prusa I3
- ↳ Software and Firmware Discussion
- ↳ Hardware Modifications
- ↳ General Questions
- ↳ Original Prusa i3 MK Series printer
- ↳ Wanhao Desktop 3D Printers
- ↳ Other make/model 3D Printers!
- ↳ Large Scale 3D Printers
- ↳ Creality Large Scale 3D Printers
- ↳ Folger Tech Large Scale 3D Printers
- ↳ Tevo brand 3D Printers
- ↳ General Large Scale Printer Area
- ↳ Resin 3D Printers
- ↳ Micro 3D Printers
- Ultimaker Printers
- ↳ Ultimaker Printers Discussion
- ↳ Ultimaker S5
- ↳ Ultimaker 3 / Ultimaker 3 Extended
- ↳ Ultimaker 2 / Ultimaker 2+ / Extended & Go
- ↳ Ultimaker Original & Ultimaker Original +
- ↳ General Discussion
- Filaments, nozzles and support material
- ↳ Filament and printing material
- ↳ Special brand filaments
- ↳ PLA Filament General Discussion
- ↳ ABS Filament General Discussion
- ↳ Speciality and Experimental Filaments
- ↳ Using different nozzle sizes
- ↳ General Filament & Nozzle chat
- Getting better prints!
- ↳ Help me fix this print!
- ↳ Show off your latest print
- Software & Electronics
- ↳ Slicers and CAD Software
- ↳ Cura
- ↳ Simplify 3D
- ↳ Other Slicing programs
- ↳ CAD and 3D Modeling Software
- ↳ Slic3r
- ↳ Electronics
- ↳ General Electronics Discussion
- ↳ Firmware
- ↳ Firmware
- ↳ Wireless Printing and Controllers
- General
- ↳ General 3D Printing Conversation
- ↳ Off Topics!
- ↳ The MarketPlace
- Modders Kiosk
- ↳ General Discussion