High Temp stuff!
ColorFabb_HT Filament
-
susanneadam
- Reactions:
- Posts: 29
- Joined: January 8th, 2019, 6:30 am
- 3D Printer(s): Ender 3
Re: ColorFabb_HT Filament
Thanks for sharing Paul.
Seems useful to my 3D printer.
Seems useful to my 3D printer.
Re: ColorFabb_HT Filament
Is this filament good bang for the buck type of a deal?LePaul wrote: ↑October 3rd, 2019, 2:07 pm Well that's totally up to the consumer....I really prefer these electric log splitters and didn't look far and high for something that could withstand 100C. I know ColorFabb makes good stuff and supports what they sell. I went back and forth with their support to fine tune my settings. I'm not sure another filament maker would do that
Last edited by TroyDan on May 11th, 2024, 8:09 pm, edited 3 times in total.
-
LePaul
- Reactions:
- Posts: 3973
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: ColorFabb_HT Filament
Well that's totally up to the consumer....I didn't look far and high for something that could withstand 100C. I know ColorFabb makes good stuff and supports what they sell. I went back and forth with their support to fine tune my settings. I'm not sure another filament maker would do that