Need help determining existing parameters Please

Printer firmware discussion
Post Reply
User avatar
Country_Bubba
Reactions:
Posts: 48
Joined: June 8th, 2019, 10:12 am
3D Printer(s): Tronxy X5S-400, Ender5
Contact:

Need help determining existing parameters Please

Post by Country_Bubba »

Hi,
OK, have a Tronxy X5s-400 and considering upgrading the control board so I can incorporate some new features in Marlin 2.x and have a better control board. :-P

I have a general idea of how to go about it, but want a base set of parameters to incorporate. Sometime in the past, I remember there was a G or M code that I could put in a terminal line that would spit out all the variables. Unfortunately, I either didn't save the info or have lost it somehow and now can't remember how to retrieve it. :?:

Can somebody please tell me the G/M code to use so I can figure out the basic info such as steps/mm, type of thermistor etc.???

Thanks in advance.
User avatar
Roberts_Clif
Reactions:
Posts: 1372
Joined: March 25th, 2017, 8:17 am
Location: Washington, State USA
3D Printer(s): Hictop 3DP11/12

Re: Need help determining existing parameters Please

Post by Roberts_Clif »

M503: Report Settings - Marlin Firmware
Last edited by Roberts_Clif on December 31st, 2019, 10:49 am, edited 1 time in total.
User avatar
Country_Bubba
Reactions:
Posts: 48
Joined: June 8th, 2019, 10:12 am
3D Printer(s): Tronxy X5S-400, Ender5
Contact:

Re: Need help determining existing parameters Please

Post by Country_Bubba »

Thanks, that is what I was looking for!
Post Reply

Return to “Firmware”