Page 1 of 1
Why is this happening?
Posted: April 12th, 2020, 4:42 pm
by Rcriss83
I have a monoprice mini select v2 and it was working fine for a few prints but then this started happening and I don't even know how to describe it to sind a solution. It always happens on that side of the bed. Any help will be appreciated
Re: Why is this happening?
Posted: April 12th, 2020, 10:29 pm
by Roberts_Clif
This is a bed leveling issue.
On one side it prints correctly, the other side is squished until the filament can no longer be extruded.
However I do not know how to correct at this time, Will search the web to see what can be found.
Watch the Bed Leveling video in this Web Link.
https://www.mpselectmini.com/bed_leveling