Tronxy X5sa pro bed dropping when print begins
-
- Reactions:
- Posts: 2
- Joined: May 15th, 2020, 5:11 pm
- 3D Printer(s): Anycubic I3 Mega, Tronxy X5sa pro
Tronxy X5sa pro bed dropping when print begins
So I have been working with 2 Anycubic I3 Mega printers with little issues, Recently decided I wanted to step up to a larger printer an was a toss between Creality CR10 v2 and the Tronxy X5sa pro. So saving a little bit of money went with the Tronxy X5sa. Finally getting a chance to work with the printer I set the Z axes then Build plate level manually and Auto. Go to do a test print an the print bed decides it wants to drop 20cm so plastic just dribbles out of extruder. The firmware is up to date and stepper motors are all good. Any help would be appreciated much thanks in advance.
- LePaul
- Reactions:
- Posts: 3979
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Tronxy X5sa pro bed dropping when print begins
Which slicer? Does it auto home correctly?
-
- Reactions:
- Posts: 2
- Joined: May 15th, 2020, 5:11 pm
- 3D Printer(s): Anycubic I3 Mega, Tronxy X5sa pro
Re: Tronxy X5sa pro bed dropping when print begins
Using Ultimaker Cura. Yes it homes correctly.