First layer problem in a Tevo Tornado with Prusa slicer.
Posted: June 12th, 2020, 6:16 pm
Hi, i have aTEvo Tornado with BLT, E3d, Marlin 1.1.8 and i am trying to set up the Tevo Tornado in Prusa Slicer, printing with pla prusament at 205 C
at 0.2 layer high
but the first layer makes some funny lines, (attach image). printing with 0.4 nozzle at 60mm/s speed.
i have try 120% first layer high and 90% layer high. also increase the first layer speed but with no good results.
i already calibrate the E steps.
Please help me
at 0.2 layer high
but the first layer makes some funny lines, (attach image). printing with 0.4 nozzle at 60mm/s speed.
i have try 120% first layer high and 90% layer high. also increase the first layer speed but with no good results.
i already calibrate the E steps.
Please help me