Page 1 of 1
Print only top 2cm of a model in Cura?
Posted: April 10th, 2016, 5:53 am
by reibuehl
I have a very tall object that I would like to do a test print of the top 2 cm (which has all the "critical" features) but due to the form, I can't just print it upside down and stop the print after 2cm. Is there a way to "cut" off the lower part in Cura? Or is there another quick way other than copying and modifying the original CAD?
Re: Print only top 2cm of a model in Cura?
Posted: April 10th, 2016, 5:59 am
by Blizz
Are you using the new beta version or the regular one?
For the regular version, if you have the advanced settings enabled:
Don't know if the beta can still do this... It probably can but I don't have it installed so can't help your there.
Re: Print only top 2cm of a model in Cura?
Posted: April 10th, 2016, 6:17 am
by reibuehl
Perfect! That was exactly what I was looking for. Many thanks!