3DP11/12

Share your hardware improvements for your HIC i3, the good and the bad!
Post Reply
User avatar
Roberts_Clif
Reactions:
Posts: 1372
Joined: March 25th, 2017, 8:17 am
Location: Washington, State USA
3D Printer(s): Hictop 3DP11/12

3DP11/12

Post by Roberts_Clif »

Have been quite busy lately of course everyone else has been to.

Hope to Get back and start working on some upgrades, I have been wanting to upgrade my inductive Proximity sensors power.
For as long as I have owned my 3D Printers I have operated all proximity sensors with a +5volt source.
I plan to add a optical coupler then supply the correct operating voltage to my Omron TL-W3MC2 driving the correct +5volt for controller operation.
Example shown below.
munY6.jpg
Do not know if it will change the operation of my 3D Printers, as I believe they are barely outside the operating voltage level now.
Post Reply

Return to “Hardware Modifications”