De-lamination of print
Posted: March 3rd, 2021, 7:58 am
Hi all
I have a problem and I don't know if it's just the filament or me.
The prints don't seem to be strong between layers and sometimes the first layer can be pealed off.
Material Sunlu PLA 1.75mm Silk silver.
Bed temp 50°
Nozzle from 190 to 210°, according to there instructions, no difference in temp.
Cura 4.8.0 settings, bed 50°C I have done different prints but have the same problem. Any ideas?
Thanks
Lez
I have a problem and I don't know if it's just the filament or me.
The prints don't seem to be strong between layers and sometimes the first layer can be pealed off.
Material Sunlu PLA 1.75mm Silk silver.
Bed temp 50°
Nozzle from 190 to 210°, according to there instructions, no difference in temp.
Cura 4.8.0 settings, bed 50°C I have done different prints but have the same problem. Any ideas?
Thanks
Lez