Page 1 of 1
Ender 3 Z rod size
Posted: October 10th, 2021, 10:59 am
by BruceY19
Hello, Does anyone know the pitch or thread size of the Z rod screw? None of my sae or metric dies fit
Re: Ender 3 Z rod size
Posted: October 11th, 2021, 7:44 am
by Roberts_Clif
There are many Z Rod diameter's and Pitch's
If you tell us more about your 3D Printer this could give us a ideal of what you have or if your 3D Printer is DIY what you may need.
Re: Ender 3 Z rod size
Posted: October 11th, 2021, 9:55 pm
by LePaul
Based on what I found here, I am guessing T8?
https://amzn.to/3AyPdSO
Re: Ender 3 Z rod size
Posted: October 12th, 2021, 7:21 am
by Roberts_Clif
I would guess a T8 x 8 myself. Unless the previous owner changed these out for alignment reasons.
It would be easier if we could see a photo showing the lead screw thread.
My 3D Printer came with a T8 x 1.25mm thread these were terrible lead screws, they was replaced with T8 x 8 - 8mm pitch per turn lead screw.
These were also terrible lead screws an wish they were never suggested for my 3D Printer.
These T8 x 8 dropped due to vibrations while the Printer was turned off, this became a hassle re-adjusting the Z-axis leveling before 3D Printing.
I again changed the lead screws to T8 x 2 these have 2mm pitch per turn. And my 3D Printer no longer needs Z-axis alignment before 3D Printing
Re: Ender 3 Z rod size
Posted: October 12th, 2021, 6:55 pm
by LePaul
I think you might be over thinking it...i mean I just Google'd up some Ender 3 specs
Re: Ender 3 Z rod size
Posted: October 15th, 2021, 11:26 am
by Roberts_Clif
It's all ok, was just trying to cover all the bases.