Slicer missing layers

Discussion of Ultimaker's open-source Cura software
Post Reply
randyd
Reactions:
Posts: 1
Joined: November 1st, 2021, 10:44 pm
3D Printer(s): Bluemaker

Slicer missing layers

Post by randyd »

model.jpg
I have my model ready to go, but when I run it through the slicer I get missing layers. The model looks fine in those areas so I don't know what it causing the missing layers and how to fix it. What could be causing this and how do I fix it? Thanks!
User avatar
LePaul
Reactions:
Posts: 3966
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

Re: Slicer missing layers

Post by LePaul »

That sounds like a bad model...what's the source? Thingiverse or?
Post Reply

Return to “Cura”