I do not have a complete board Connector Pin-out.
Please supply me any information you may have regarding connector labeled with an " H6 ".
Thank You
Hictop Controller Pinout
-
Roberts_Clif
- Reactions:
- Posts: 1363
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Hictop Controller Pinout
I have a controller from Hictop MPK V1.
I do not have a complete board Connector Pin-out.
Please supply me any information you may have regarding connector labeled with an " H6 ".
More information they replaced the FT232RL - FTDI with an ATmega 16U2 High Speed USB controller this is where H6 connects.
Thank You
I do not have a complete board Connector Pin-out.
Please supply me any information you may have regarding connector labeled with an " H6 ".
More information they replaced the FT232RL - FTDI with an ATmega 16U2 High Speed USB controller this is where H6 connects.
Thank You