Trouble installing CR Touch

Printer firmware discussion
Post Reply
MattM
Reactions:
Posts: 1
Joined: April 25th, 2022, 9:37 am
3D Printer(s): Ender 3

Trouble installing CR Touch

Post by MattM »

I have been trying for a couple hours to install the CR Touch on a Ender 3 with the 4.2.2 32 bit board. I have downloaded the bin file, formatted the SD card and put only the Ender-3- Marlin2.0.1 – V1.1.2 – ALT.bin file on it. When I insert it into the printer and turn the printer on, it doesnt seem to read the SD card and update anything. The BL menu doesnt get added to the controls and when I go to About Printer nothing new is added there as far as information goes. I have tried installing the hardware, because in a video I saw it said that the firmware for the 4.2.2 board might already have the BL/CR software installed but the hardware being installed didnt change anything either. The CL Touch does power up with the printer and has a red LED on in it so I know physically it is working. Any ideas what I am doing wrong? Any help would be greatly appreciated. Matt
Post Reply

Return to “Firmware”