I set the offset for print height on the nozzle, but when I print it is to low to the bed. no matter what I make the offset the print head has to be manually raised during print start or its to low. also if (when in manual mode) when z is at 0.000 i can not move below that even though I am not at the hard/soft stop.
Geeetech A20m
Marlin 2.1.x (6/25/2022)(bug fix release)
nozzle/bed offset
- LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: nozzle/bed offset
Well, let me offer this...one of my favorite videos on the Z Offset You didnt mention a BL Touch of probe but i think that machine has one
-
- Reactions:
- Posts: 4
- Joined: July 15th, 2022, 3:52 am
- 3D Printer(s): Anycubic Mega-S