Hello,
I am using an Ender-5 and Cura 5. I never really had problems with my prints, but recently I have gaps in all of them in the x-y direction. Even in between of the walls are gaps now. Does anyone have an Idea how to fix it? The outer Dimensions of the parts are spot on so I dont want to increase the flow rate. And its not just the first layer.
Cura gaps in prints
-
- Reactions:
- Posts: 2
- Joined: December 7th, 2022, 12:24 pm
- 3D Printer(s): Ender 5
- Roberts_Clif
- Reactions:
- Posts: 1386
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: Cura gaps in prints
It could be a value applied to the Cura Overlap.
Post your Cura profile
Post your Cura profile
-
- Reactions:
- Posts: 2
- Joined: December 7th, 2022, 12:24 pm
- 3D Printer(s): Ender 5
Re: Cura gaps in prints
Ok so what do you recommend changing?
Here are the printer Settings.
Here are the printer Settings.
- Attachments
-
- Cura Settings Export12.pdf
- (155.41 KiB) Downloaded 111 times
- Roberts_Clif
- Reactions:
- Posts: 1386
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: Cura gaps in prints
Try changing these
Line Width 0.45 mm
Wall Line Width 0.45 mm
Outer Wall Line Width 0.45 mm
Inner Wall(s) Line Width 0.45 mm
Top/Bottom Line Width 0.45 mm
Infill Line Width 0.45 mm
Skirt/Brim Line Width 0.45 mm
Support Line Width 0.45 mm
Line Width 0.45 mm
Wall Line Width 0.45 mm
Outer Wall Line Width 0.45 mm
Inner Wall(s) Line Width 0.45 mm
Top/Bottom Line Width 0.45 mm
Infill Line Width 0.45 mm
Skirt/Brim Line Width 0.45 mm
Support Line Width 0.45 mm
- LePaul
- Reactions:
- Posts: 3979
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Cura gaps in prints
Based on the skirt line, your z offset looks good
You've already calculated your slicer flow settings?
https://teachingtechyt.github.io/calibration.html#flow
You've already calculated your slicer flow settings?
https://teachingtechyt.github.io/calibration.html#flow