Hello!!
Super new to resin printing. Just purchased and Anycubic Mono 2 4k.
Ran the test print cube, came out awesome!
I purchased 2 stl files from Hero Forge for 2 DnD minis.
I imported both files into the Anycubic photon workshop. Made certain my files were hollow, added the auto supports and removed 2 or three that had bad placement.
I saved as a new .stl and then sliced, saving as a .pm3n file.
Below are photos, any idea what happened??
Whitney
What the heck happened here??
- LePaul
- Reactions:
- Posts: 3978
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: What the heck happened here??
I'm not as savvy with resin as others, but I know there is a issue where suction can pull the part off or deform it