Slic3r Prusa Edition

Discussion of the G-code generator for 3D printers
Posts: 3
Joined: January 1st, 2017, 5:04 pm
3D Printer(s): Hictop Prusa

Slic3r Prusa Edition

Post by doodady »

Anyone having luck with this?

I have been using Prusa Edition for 1.31.6 for a while now.

Still having trouble dialing in the Hic i3 prusa.

specifically overhangs. Also sometimes it want to bridge into mid-air.

Thinking about slamming $$ at simplify 3d but wanted to give this version a chance before doing so.

Return to “Slic3r”