Well I can't recall which version had this issue last time....removed 2.3.1 from PC and installed 2.4 Beta.
I get the logo...then nothing
I thought they fixed this issue last time around
Cura 2.4 beta won't load
- Izzy
- Reactions:
- Posts: 604
- Joined: February 12th, 2016, 2:29 am
- Location: England
- 3D Printer(s): Ultimaker 2
Re: Cura 2.4 beta won't load
Check your virus software,
When this happened to me last time, I had to tell the virus software that curator was a good program and to let it run.
When this happened to me last time, I had to tell the virus software that curator was a good program and to let it run.
- LePaul
- Reactions:
- Posts: 3974
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Cura 2.4 beta won't load
I had to rename the Cura folder under AppData.
Loads now
Loads now