Page 1 of 1
Marlin 1.1 is out!
Posted: May 10th, 2017, 2:21 am
by GrueMaster
It was released May 4th. Has anyone else downloaded it yet?
I have a clone of the tree. Will try to look at it in the next few days. Lots of changes since RC8.
Re: Marlin 1.1 is out!
Posted: May 10th, 2017, 3:07 am
by drayson
jupp - there seems to be a lot of reork in it - especially compared with the "old" release.
Downloaded it, but not uploaded/tested it up to now on my UMO.
From my point of view, one key feature is still missing: move away the printhead when klicking on "stop" in menue..
But a behavior for "pause" should be in now...
What I like is the sorting of the SD card content alphabetical.
we will see how usable it is...
Re: Marlin 1.1 is out!
Posted: June 7th, 2017, 9:29 pm
by Chaco
i downloaded it last month, edited my settings, compiled it, and its been working great so far.
Re: Marlin 1.1 is out!
Posted: June 8th, 2017, 6:43 am
by drayson
there is already an update - 1.1.3
unfortunately I did something wrong with setup so my UMO makes strange things (does not home propperly, ignores endstops...)
Re: Marlin 1.1 is out!
Posted: June 8th, 2017, 9:00 am
by LePaul
Oh that's not good
Re: Marlin 1.1 is out!
Posted: June 9th, 2017, 4:13 pm
by drayson
tried to setup comletely new with a new downloaded version.
honestly, I have no idea what happens...
Z reading shows a "?" at the display, when trying to home via G28 it makes a short movement, seems to ignore the endstops.
crosschecked twice to set the same values/definition as in my working version.
Any hint is appreciated...