So both printers aren't able to be seen on my laptop on Cura or my app
I haven't tried going through the setup again
The wifi/local LAN is DHCP....is it normal for these fellas to drop off the network?
Wifi ?
Re: Wifi ?
If you manualy connect to them, are they reachable?
- LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Wifi ?
Well what's interesting is they are showing IPs and when I enter that into the app, I still can not connect to them
I haven't touched my Netgear router, are there any settings I need to make?
The reason I ask is I've never had to intervene. The laser printers are on the DHCP LAN and never fallen off like this
I haven't touched my Netgear router, are there any settings I need to make?
The reason I ask is I've never had to intervene. The laser printers are on the DHCP LAN and never fallen off like this