Having spent a month with this printer, I thought it was time to collect my thoughts and do a review!
https://youtu.be/pl9flKbUSvs
My Review of the Ultimaker 3
- darkdvd
- Reactions:
- Posts: 53
- Joined: February 27th, 2016, 6:01 am
- Location: France
- 3D Printer(s): UM2/UM2+
Re: My Review of the Ultimaker 3
note for Paul : You need a microphone
- LePaul
- Reactions:
- Posts: 3974
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: My Review of the Ultimaker 3
I had two. Both suck
- LePaul
- Reactions:
- Posts: 3974
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: My Review of the Ultimaker 3
Following up on this....I do miss the Ultimaker 3. The autolevel and PVA supports were really great. The size was a bit disappointing, since my BB-8 pieces were just a bit larger than the available print volume. (Wider...)
Knowing that Cura now has that Support Interface Layer, to use less PVA, would be great to try out.
Knowing that Cura now has that Support Interface Layer, to use less PVA, would be great to try out.