I bought a sample 225G roll of
Marble filament to see how it looked. Not bad. First print on my CR-10S, no complaints.
Printed at 200c, Bed 60c (have to use a glue stick currently), Layer Height .2, 20% infill. Sorry, forgot to put my US quarter next to it for scale, but it is ~5x1x4.4 CM (so miniature D&D scale).
AMOLEN Marble Color PLA
- GrueMaster
- Reactions:
- Posts: 522
- Joined: March 15th, 2017, 8:46 pm
- Location: Oregon
- 3D Printer(s): Hictop 3DP-17, Hictop CR-10S
- GrueMaster
- Reactions:
- Posts: 522
- Joined: March 15th, 2017, 8:46 pm
- Location: Oregon
- 3D Printer(s): Hictop 3DP-17, Hictop CR-10S
Re: AMOLEN Marble Color PLA
BTW, this was on draft quality. The layer lines show up more in the photo than they do IRL.
- LePaul
- Reactions:
- Posts: 3978
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: AMOLEN Marble Color PLA
That's pretty neat looking