Bondtech feeder running backwards
Posted: March 18th, 2018, 6:48 am
Hi guys.
I needed to replace my headed bed this week, after 3.5 years one of the connections developed an intermittent fault, and despite an attempt to resolder it, it lasted a couple of small prints before failing again, so a new one was purchased, it has better connections but a bit steep at £170.
So I also upgraded the firmware, first time in 18 months, reinstalled the custom firmware for the Bondtech feeder, reset the machine, Emergancy stop during set up to disassembly the lower part of the print head, ( it tried to raise the bed and park the head in the home position, as I have Gudo’s bed stability struts fitted it clashes) re level the bed roughly minus lower print head, reassembly head and level the bed again, but now my Bondtech QR feeder is running backwards, any help etc. Anybody
I needed to replace my headed bed this week, after 3.5 years one of the connections developed an intermittent fault, and despite an attempt to resolder it, it lasted a couple of small prints before failing again, so a new one was purchased, it has better connections but a bit steep at £170.
So I also upgraded the firmware, first time in 18 months, reinstalled the custom firmware for the Bondtech feeder, reset the machine, Emergancy stop during set up to disassembly the lower part of the print head, ( it tried to raise the bed and park the head in the home position, as I have Gudo’s bed stability struts fitted it clashes) re level the bed roughly minus lower print head, reassembly head and level the bed again, but now my Bondtech QR feeder is running backwards, any help etc. Anybody