Prints don't start after Tinkergnome Firmware Update
-
- Reactions:
- Posts: 506
- Joined: February 9th, 2016, 9:56 am
- Location: Stuttgart, Germany
- 3D Printer(s): Ultimaker 2
Prints don't start after Tinkergnome Firmware Update
I upgraded my UM2 with Dual Extruders today from Tinkergnome firmware version 16.09 to 17.10.1 using the Tinker-MarlinUltimaker2-dual-17.10.1.hex file. Now I have the strange behavior that when I start a print, the printer heats up the buildplate and nozzle and then just sits there at "Heating up... 100%" and doesn't start the print:
Did I do something wrong?-
- Reactions:
- Posts: 506
- Joined: February 9th, 2016, 9:56 am
- Location: Stuttgart, Germany
- 3D Printer(s): Ultimaker 2
Re: Prints don't start after Tinkergnome Firmware Update
With the stock firmware that ships with Cura 15.04, the printer prints fine. Strange...