Page 2 of 2
Re: Marlin 1.1.9 Setup Problems
Posted: October 21st, 2019, 5:09 pm
by Roberts_Clif
Mr SNG wrote: ↑October 21st, 2019, 4:44 pm
So how do you tweak Z when the machine is printing?
Not sure I understand.
you can adjust Z Axis when printing using baby stepping
#define BABYSTEPPING
Though I believe your referring to Tweak at Z, you can Change printing parameters at a given height.
- Tweak at Z.jpg (24.8 KiB) Viewed 7184 times
Re: Marlin 1.1.9 Setup Problems
Posted: October 22nd, 2019, 3:56 am
by Mr SNG
Just googled 'Marlin Baby Setting' now fully understand about this cool feature.
Thanks again for another useful heads up.