3D Printing Forum

Hello,
I am using an Ender-5 and Cura 5. I never really had problems with my prints, but recently I have gaps in all of them in the x-y direction. Even in between of the walls are gaps now. Does anyone have an Idea how to fix it? The outer Dimensions of the parts are spot on so I dont want to increase the flow rate. And its not just the first layer.

It could be a value applied to the Cura Overlap.

Post your Cura profile

Ok so what do you recommend changing?
Here are the printer Settings.

Try changing these

Line Width 0.45 mm
Wall Line Width 0.45 mm
Outer Wall Line Width 0.45 mm
Inner Wall(s) Line Width 0.45 mm
Top/Bottom Line Width 0.45 mm
Infill Line Width 0.45 mm
Skirt/Brim Line Width 0.45 mm
Support Line Width 0.45 mm

Based on the skirt line, your z offset looks good

You've already calculated your slicer flow settings?

https://teachingtechyt.github.io/calibration.html#flow