How much too high!
Could you post a closeup photo of the Z-Axis Lead screws
How much too high!
Code: Select all
#define GRID_MAX_POINTS_X 5
#define GRID_MAX_POINTS_Y 5
// Set the boundaries for probing (where the probe can reach).
#define LEFT_PROBE_BED_POSITION 10
#define RIGHT_PROBE_BED_POSITION 210
#define FRONT_PROBE_BED_POSITION 63
#define BACK_PROBE_BED_POSITION 245
Code: Select all
#define GRID_MAX_POINTS_X 6
#define GRID_MAX_POINTS_Y 6
// Set the boundaries for probing (where the probe can reach).
#define LEFT_PROBE_BED_POSITION 10 // 10 For SN04-N and 20 for for TL-W3MC2
#define RIGHT_PROBE_BED_POSITION 205 // 205 For SN04-N and 200 for for TL-W3MC2
#define FRONT_PROBE_BED_POSITION 63 // 63 For SN04-N and 25 for for TL-W3MC2
#define BACK_PROBE_BED_POSITION 245 // 245 For SN04-N and 260 for for TL-W3MC2
1. No!!! I think we all spend too much for our hobbies. Though What else are we going to do with our money and time - Watch TVEllou wrote: ↑September 1st, 2020, 9:39 am 1. Do you think this printer is worth throwing a couple hundred dollars at?
2. psu voltage drops to 8.5-9v when heating and during print
3. Z lead screws have a wobble at the top
4. I don't think the extruder has enough tension anymore
5. after switching out old bed bearings and adding tensioner to y belt it no longer glides smoothly
6. finally it's an off brand printer that not a lot of people have/use
7. I would like to have at least 2 good working printers and for the basics I need for the hictop I could just by an ender 3 with a little extra money.
8. Updated extruder $$???
I hate the sn04 setup
I have attached my Cura 15.04.6 and Cura 3.6.0 profiles.Ellou wrote: ↑September 2nd, 2020, 10:56 am Throats, nozzles, and heat blocks yes.
My job requires stickers on my phone cameras so I'll get you some picks tonight since it's my Friday.
Just changed all 3 because I was getting clogs for the first time. Turns out my retraction was set to high in cura. I need to make my own profiles. The ender 3 profiles are ok but for this one it's way off. I think so anyway.