Hello Community,
I tried hard to find a Solutionbut I dont know wich setting I have to tweak to get rid of the following Problem. At the End of each area of a layer the Extrusion stopps too early. I uploaded a picture of the Problem.
I hope someone can help me.
Thank you.
Cura Setting, Stops extrusion too early
-
- Reactions:
- Posts: 1
- Joined: October 11th, 2022, 5:57 pm
- LePaul
- Reactions:
- Posts: 3982
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Cura Setting, Stops extrusion too early
Check if you have Coasting enabled
- Roberts_Clif
- Reactions:
- Posts: 1387
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: Cura Setting, Stops extrusion too early
I would also check to see if infill/perimeters overlap by 25%